Developed for professionals in agricultural work, such as outsourcers, this mulcher is a versatile machine able to face any kind of job.
Perfect for maintenance on road sides and banks, where there are difficult vegetation to remove, such as brambles and shrubs, the mulcher can also be used to mulch runners and stalks.
Thanks to the Tierre patented double-edged hammer and the anti-clogging wheel, the TCL MASTER mulcher easily faces the most extreme work conditions.
- Tractor linkage Cat. 3
- Oil sealed transmission with double free wheel
- Supporting slides height adjustable
- Toothed belts
- Rotor bearings with double oscillating roller
- Electronically balanced rotor
- Rotor diameter 194mm
- Supporting roller with scraper, height adjustable
- Roller diameter 194mm
- Cutting speed 52 m/sec.
- Impact device on 2-point linkage with blocking system
- Hydraulic accumulator on work corner control
- High resistance rotor
- Double cutting hammer - TIERRE patent
- HARDOX double frame
Impossible becomes simple.
A new concept of shredder able to change the shape of the cutting chamber up to 12 ways.
Each cutting configuration suits a different job that the machine can perform.
As a result, the same machine can be used in completely different working environments.
From mowing grass to pruning, or simply in the open field.
This is the TIERRE ADAPTIVE GEOMETRY patent, registered in 142 countries.
HAMMERS DOUBLE EDGED INNOVATIVE AND PATENTED
double cutting surface both horizontally and vertically
low drag, less fuel consumption
greater impact resistance against rocks and stony bodies due to the particular shape of the neck
The hammers are mounted on a steel screw 12.9 with a diameter of 16 mm and are fixed to the rotor by means of supports made of boron steel.
POSSIBILITY OF ASSEMBLE KNIVES IN DIFFERENTS SETTINGS
• Knives Y, ideal for cutting and quickly discharge.
• Knives Y and vertical knive, ideal for grinding.
The knives are mounted on a nitrided bushing, which in turn is mounted on a screw. This greatly reduces the wear of the knife if it was mounted directly on the screw.
SUPPORT ROTOR AND BEARING
Rotor lateral supports are made of pressed steel,and then worked in order to obtain a single body without welding.
Supports are mounted on double ball bearings highly professional working with labyrinth which means double double lip seals.
SKID WITH WHEEL ANTI-CLOG PATENTED
Reason of distinction and pride, the wheel anti-clog of Tierre favors the continuity of work due to the fact that the prunings can no longer stand on the side of the forage harvester.
This detail allows the operator does not have to get off the tractor to release pruning waste, increasing productivity.
The gearbox is made by COMER and is bathed in oil, as well as the extension.
The lateral transmission has 4 belts mounted in pulleys that have been balanced electronically independently.
Pulleys electronically calibrated independently
The rear roller support with adjustable height is 194 mm in diameter
Undoubtedly the largest of its kind.
The rullo is mounted on an oscillating field bearing, which in turn is inserted in a special holder of galvanized steel.
The assembly is easily adjustable through holes for regulazión height.
PAINTING AND SPECIAL ZINC
Paint of Tierre machines is done with epoxy powder.
All parts are painted separately before assembly in an oven at 180 ° C for 3 hours.
This system ensures the total resistance of the machine to atmospheric agents.
The parts are assembled with different faces that touch the paint with paint, ensuring the life of the machine.
The galvanized parts of the machine are provided by zinc bath at a temperature of 450 ° C